Electronics projects

These projects pair printed parts with electronics, such as a microcontroller board, servos, motors or LEDs. The printed parts are designed around the boards, motors and batteries they hold.

Electronics

Round robot chassis

A two-wheel robot base that spins in place, with plates for an Arduino Uno, an ESP32 or a Pico.

Electronics

Snap-lid board enclosure

A soft, rounded case for an Arduino Uno, an ESP32 or a Pico, with a lid that snaps on.

Halloween

Light-up pumpkin lantern

A deeply carved jack-o'-lantern lit by an LED ring and a Raspberry Pi Pico.

Electronics

Animatronic eyes with lids

Eyes that glance about and blink behind a sculpted face, with upper and lower lids on their own servos.

Electronics

4 inch FPV quad frame

An organic 4 inch FPV frame in PETG with bolt-on arms, so a crash costs one arm, not the frame.

Toys and RC

Self-righting RC speed boat

A 472 mm deep-V racer with a fastback canopy and rear wing that rights itself, printed in vase mode.

Toys and RC

Pylon racer RC plane

A 716 mm low-wing pylon racer in foaming PLA for a 2306 quad motor on 4S.

Toys and RC

5 inch speed quad frame

A printed 5 inch speed quad of my own design, built round its thrust axis like the record breakers.